Vorträge und Posterpräsentationen (mit Tagungsband-Eintrag):

M. Hospodka, B. Hofko, R. Blab:
"Assessing the performance of asphalt mastic by dynamic shear rheometer fatigue testing";
Vortrag: International Society for Asphalt Pavements, ISAP 2018, Fortaleza, Brasilien; 19.06.2018 - 21.06.2018; in: "Proceedings: ISAP 2018", (2018), 8 S.

Kurzfassung englisch:
Early failure of asphalt pavements is a common issue all around the world. Damages are caused by various reasons like binder or aggregate quality, an inadequate mix design or improper handling in the construction process. The effects of binder, aggregates and mix design have been widely studied and state-of-the-art testing methods are available for both, hot-mix asphalt (HMA) and for each component. An important part in HMA belongs to the asphalt mastic, where no standardized method is available to allow a quality control. Asphalt mastic is the mix of bitumen with aggregates smaller than 63 (125) μm and covers the coarse aggregates as the actual binding component in the mix. This research aims at developing a testing method for asphalt mastic based on fatigue tests. The dynamic shear rheometer (DSR) was found as a suitable device for this purpose. The DSR fatigue test consists of the 8 mm parallel-plate geometry widely used for binder performance grading with a sample height of 3 mm. Instead of a cylindrical specimen shape, a hyperboloid of one sheet is applied. This shape predetermines the point of failure and prevents from adhesion/interface failures between the mastic specimen and the upper or lower DSR stainless steel plate. The specimens are prepared directly in the DSR employing a silicone mould to ensure an exact specimen shape. This test can be applied to all DSR devices without costly changes or additional equipment as long as sufficient cooling capacity and torque can be provided from the DSR.

mastic, filler, fines, fatigue, DSR

Elektronische Version der Publikation:

Erstellt aus der Publikationsdatenbank der Technischen Universitšt Wien.