Beiträge in Tagungsbänden:
A. Khorami, R. Saeidi, M. Sharifkhani, N. TaheriNejad:
"An Ultra Low-power Low-offset Double-tail Comparator";
in: "IEEE New Circuits and Systems symposium (NewCAS)",
IEEE,
Munich,
2019,
4 S.
Kurzfassung englisch:
In double tail comparators, the pre-amplifier
amplifies the input differential voltage and when the output
Vcm of the pre-amplifier becomes larger than Vth of the latch
input transistors, the latch is activated and finalizes the
comparison. As a result, the pre-amplification delay is fixed to
a value and cannot be set at the minimum required delay, to
save power and improve offset. In fact, when the latch is
activated the pre-amplifier output differential voltage is still
growing but the latch finishes the comparison before the
maximum differential gain is formed and applied to the latch.
In this paper, a comparator is proposed in which the preamplifier
is turned off when the maximum gain is achieved so
that always the maximum possible gain is applied to the latch.
Therefore, not only the input referred offset is improved but
also the power consumption of the pre-amplifier is saved.
Simulations in 0.18μm technology show with an appropriate
pre-amplification delay the average power is saved by up to
75% while the offset voltage is reduced by about 30%.
Schlagworte:
double tail comparator; low-offset comparator; low-power comparator; appropriate pre-amplification delay;
Erstellt aus der Publikationsdatenbank der Technischen Universität Wien.