[Back]

J. Frühhaber, C. Lieber, D. Mattes, T. Lauer, R. Koch, H. Bauer:
"Modeling the Formation of Urea-Water Sprays from an Air-Assisted Nozzle";
Applied Sciences, Heft 16 / Verlag MDPI (2020), Article no: 5723.

Ammonia preparation from urea-water solutions is a key feature to ensure an e ective
reduction of nitrogen oxides in selective catalytic reduction (SCR) systems. Thereby, air-assisted nozzles provide fine sprays, which enhance ammonia homogenization. In the present study, a methodology was developed to model the spray formation by means of computational fluid dynamics (CFD) for this type of atomizer. Experimental validation data was generated in an optically accessible hot gas test bench using a shadowgraphy setup providing droplet velocities and size distributions at designated positions inside the duct. An adaption of the turbulence model was performed in order to correct the dispersion of the turbulent gas jet. The spray modeling in the near nozzle region is based on an experimentally determined droplet spectrum in combination with the WAVE breakup model. This methodology was applied due to the fact that the emerging two-phase flow will immediately disintegrate into a fine spray downstream the nozzle exit, which is also known from cavitating diesel nozzles. The suitability of this approach was validated against the radial velocity and droplet size distributions at the first measurement position downstream the nozzle. In addition, the simulation results serve as a basis for the investigation of turbulent dispersion phenomena and evaporation inside the spray.

http://dx.doi.org/10.3390/app10165723

https://publik.tuwien.ac.at/files/publik_293149.pdf